|Home||» Products||» Light Diesel Oil||» Fuel Oil / Bio Furnace|
Light Diesel Oil falls under class C category fuel having flash point above 66OC. It is a blend of distillate components and a small amount of residual components. It is marketed under BIS 1460-2000 specification for Diesel fuels. We deals in Brand like Castrol, Hindustan Petroleum (HP), Indian Oil Corporation (IOC), Gulf, Veedol
LDO is used in lower RPM engines. It is used in Lift irrigation pump sets, DG Sets and as a fuel in certain boilers and furnaces.
Reactivity Data Chemically stable and incompatible with strong oxidizers. Does not React vigorously with common materials but may react with oxidizing agents
Health Hazard Data Ã¢â¬Å¡ Routes of entry may be through inhalation/ ingestion/ skin/ eye.
EFFECTS OF EXPOSURE / SYMPTOMS
Inhalation causes dizziness and headache.
Ingestion may lead to nausea vomiting, irritation of mouth and gastro-intestinal effects likely. Potentially fatal chemical pneumonitis.
On Skin and eye contact , irritation will remove natural fats from skin. Prolonged or repeated contact should be avoided, Otherwise skin chapping or cracking or possible contact of dermatitis may result. Dry skin, erythema oil acne and oil folliculitis and warty growth may occur which may become skin cancer subsequently on excessive repeated exposure.
Inhalation Ã¢â¬Å¡ Remove victim to fresh air. Give artificial respiration if necessary. If unconscious but breathing, place in recovery (Unconscious) position and give external cardiac massage if necessary.
Ingestion Ã¢â¬Å¡ Do not induce vomiting. Remove contaminated clothing. Wash all affected skin thoroughly with soap and water.
Eyes Ã¢â¬Å¡ Irrigate eyes with copious amounts of water. Administration of medical paraffin may reduce absorption through digestive tract.
Gastric lavage should be done only after endo tracheal intubation in view of respiration which may cause serious chemical pnemonitis for which antibiotic and cortico-steroid therapy may be indicated.
Requirements for Light Diesel Oils (Clause 4.2)
|No.||Characteristic||Requirement for LDO||Method Of Test|
|2.||Acidity, total mg of KOH/G, Max||
|3.||Ash, percent by mass, Max||0.02||P:4|
|4.||Carbon residue (Ramsbottom) on 10 percent residue, percent by mass, Max||1.5||P:8|
|5.||Cetane number, Min||
|6.||Pour point, Max||12oC for winter and 21oC for summer||P:10|
|7.||Copper strip corrosion for 3 h at 100oC||Not worse than No. 2||P:15|
|8.||Distillation 90 percent volume recovery at oC, Max||
||Abel, o C, Min||
||Pensky-Martens, oC, Min||66||P:21|
|10.||Kinematic viscosity, cSt, at 40o C||2.5 to 15.7||P:25|
|11.||Sediments, percent by mass, Max||0.10||P:30|
|12.||Density at 15oC, kg/m2||
|13.||Total sulphur, percent by mass, Max||1.8||P:33|
|14.||Water content, percent by volume, Max||0.25||P:40|
|15.||Cold Filter Plugging Point (CFPP), Max||